Bosch NWD-495V03-20P - Attach the Mounting Plate; Make the Connections

FlexiDome
DN
IP Mounting the unit | en 23
Bosch Security Systems Operating Instructions V 1.0 | 2006.12
3.1 Attach the mounting plate
1. Use the mounting plate as a drilling temple to drill three
holes in the mounting surface.
2. Use the supplied plugs and screws to attach the mounting
plate to the surface.
3. With a rear connection, leave the cap in place. With a side
connection:
a. remove the cap covering the side entrance;
b. attach a 22 mm / ½ inch (PG16) gland conduit to the
mounting plate.
3.2 Make the connections
To connect the wiring to the camera, use the metal mounting
wire to hold the camera during installation on a ceiling. Make
the power and network connection from inside the connection
box.
Fig. 3.3 Preparation
1. Pull out the connection box from the camera encasing.
2. To open the connection box, loosen the Phillips screws,
and open the cover flips.
Suspension wire
Connection box
!
CAUTION!
Never supply power via the Ethernet connection (PoE) when
power is supplied via the power connector.