FlexiDome
DN
IP Camera set-up | en 27
Bosch Security Systems Operating Instructions V 1.0 | 2006.12
– Press the menu/select
(center) key to access the
menus or to move to the
next or previous menu.
– Press the menu/select
key for approximately 1.5
seconds to open the
Installer menu.
– Use the up or down keys to scroll through a menu.
– Use the left or right keys to move through options or to set
parameters.
– When in a menu, quickly pressing the menu/select key
twice restores the selected item to its factory default.
4.3.1 Install menu
Table 4.1 Install menu
Install IP address submenu
To operate the camera in your network, a network-valid IP
address must be assigned. The IP address can also be set
remotely via the Configuration Manager. This SW package is
supplied with the camera on the CD. The factory default IP
address is 192.168.0.1
Table 4.2 IP address submenu
Up key
Menu/select key
Right key
Down key
Left key
Function Selection Description
Network Select submenu Select to set the network IP address for the
camera (default address is 192.168.0.1)
Exit Exit the menu
Function Description
IP Address Enter an IP address for the camera. Use LEFT/RIGHT to
change position in the address, use UP/DOWN to select
the digit. Use SELECT to exit the address edit screen.
Subnet Mask Enter the Subnet mask (default 255.255.255.0)
Gateway Enter a Gateway address.
Exit Return to the Install menu
To Next Page
Loading...
