Bosch PCM 10 - Page 32

English–31 609 929 J60 • (05.12) PS
Always use saw blades of the correct size and
with matching mounting holes (e. g., star?form or
round). Saw blades that do not fit to the mounting
parts of the saw run out of balance and lead to loss of
control.
Do not use saw blades of high alloy steel (HSS
steel). Such saw blades can easily break.
Do not take hold of the saw blade after working
before it has cooled. The saw blade becomes very
hot while working.
Never use the power tool without the table insert.
Replace a defective table insert. Without a table in
sert plate that is free of defects, injuries can occur on
the saw blade.
Do not direct the laser beam at persons or ani?
mals and do not look into the laser beam, also
not from greater distances. This machine gener
ates laser radiation of the laser class 2 according to EN
608252:2001. Unintentional blinding of other persons
could result if not observed.
Do not allow children to use the power tool with
laser without supervision. They could blind other
persons.
Do not replace the built?in laser with a laser of
another type. A laser that was not intended for this
power tool could be dangerous to persons.
Bosch can ensure flawless functioning of the machine
only when original accessories intended for the ma
chine are used.
SYMBOLS
Important notice: Some of the following symbols could have meaning for the use of your power tool. Please
take note of the symbols and their meaning. The correct interpretation of the symbols will help you to use the
power tool in a better and safer manner.
Symbol Name Meaning
VVolts Voltage
A Amperes Current
Ah Amperehours Capacity, quantity of stored electrical energy
Hz Hertz Frequency (cycles per second)
WWatt Power
Nm Newtonmeter Unit of energy
kg Kilograms Mass, weight
mm Millimetre Length
min/s Minutes/Seconds Time
°C/°F Degrees Celsius/Degrees
Fahrenheit
Temperature
dB Decibel Unit of relative loudness
∅ Diameter Size of drill bits, grinding wheels, etc.
min
1
/n
0
Revolutions per minute/no load
speed
Rotational speed at no load
…/min Revolutions or reciprocation per
minute
Revolutions, strokes, surface speed, orbits, etc.
per minute
0 Off position Zero speed, zero torque...
SW Spanner width (in mm) Distance between parallel surfaces on fastener el
ements on which the tool must fit on (e.g. hex nuts
or hexhead screws), fit over (e.g. ring spanner) or
fit in (e.g. sockethead screws).
Left rotation/Right rotation Direction of drive rotation
PCM10_WEU.book Seite 3 Donnerstag, 1. Dezember 2005 9:16 09