32 en | Operation PLENA matrix
2020-12 | V1.1 |
User manual
Bosch Security Systems B.V.
8 Operation
Call stations and wall control panels can only operate when connected to the DSP matrix
mixer and individual IDs have been set via the DIP switches on the units. Refer to
Call Station
DIP switch settings, page 23
and
Wall Control Panel DIP switch settings, page 24
.
The multi channel DSP amplifier can operate both as a standalone amplifier or connected to
the DSP matrix mixer.
8.1 Start
1. Check that all connections have been made to relevant units in the system including wall
control panels and call stations.
2. Power on the DSP matrix mixer followed by the amplifiers.
3. Check that the power LED are illuminated on the front of the DSP matrix mixer and
amplifier(s) (19” rack unit(s)).
4. Check that the RS485 LED is flashing for connections to the wall control panels and call
stations.
5. Make sure that the level controls on the rear of the amplifier are set to the desired level.
6. For use with the PC GUI software, Click “Device” from the menu bar, and then
“Connect”. Refer to
PC GUI software, page 16
.
– If the above steps have been followed the system should be in its last mode of operation.
However, if this is the initial power‑up of the system, it will be obviously be in its factory
default state.
– If all of the above steps have been followed and the system is not working correctly, refer
to the
Troubleshooting, page 41
section of this manual.
Continue with one of the following chapters:
–
Call Station, page 33
–
Wall Control Panel, page 35
–
Multi Channel DSP Amplifier, page 37
–
DSP Matrix Mixer, page 39
To Next Page
Loading...
