Control
The Control menu is used to set the port on which the command data stream is received.
Figure 6.6: Control screen (default)
UDP command port
Default: 12301
This sets the port through which the device will receive commands via UDP. To disable this
port, set to 0.
Web server port
Default: 0
This sets the port through which the web server of the device can be reached. If set to 0, the
default port 80 is used.
Submit / Cancel button
Submit saves the set values, restarts the device and returns back to the last screen. Cancel
restores the last submitted values.
6.2.5
IP Audio Interface Configuration | en 23
Bosch Security Systems B.V. Operating Manual 2013.03 | V2.0 |
To Next Page
Loading...
