SNMP Community RWrite
Default: not protected
Select the SNMP access rights for the Read and Write Community. You can select between:
not protected, Configuration/Update, Status Page View, Command/Reboot and no write access.
SNMP Community Read
Default: not protected
Select the SNMP access rights for the Read Community. You can select between: not
protected, Configuration/Update, Status Page View, Command/Reboot and no access.
Note that the Community RWrite setting takes priority. This means that if the Community
RWrite is set to not protected, Community Read is ignored.
Submit / Cancel button
Submit saves the set values, restarts the device and returns back to the last screen. Cancel
restores the last submitted values.
Default settings
Figure 6.14: Default settings screen
Default settings
Clicking Back to factory defaults button to restore the factory defaults (except Network
configuration). During the restart a countdown screen will appear. Then the successful loading
of the factory defaults is confirmed.
Hard default settings
To revert all settings (including the Network configuration) to factory defaults, the Reset
button (1) has to be pressed for about 5..10 seconds while the device is powered.
6.2.13
34 en | Configuration IP Audio Interface
2013.03 | V2.0 | Operating Manual Bosch Security Systems B.V.
To Next Page
Loading...
