English–41 609 929 J73 • (06.03) PS
Indicates the direction of rotation of the hand wheel for the lowering
(transport position) and raising (working position) of the saw blade.
Perform the setting of the vertical bevel angle (tilting of the saw blade)
in the indicated sequence.
Indicates the maximum allowable height of a work piece at the standard
vertical bevel angles of 90° and 45°.
Observe the dimensions of the saw blade. The hole diameter must fit
the tool spindle without play. Do not use reducer pieces or adapters.
Pay attention when changing the saw blade that the cut width is not
smaller than 2.6 mm and the basic blade thickness is not larger than
1.8 mm. Otherwise, the danger exists that the riving knife (2.5 mm) will
jam in the work piece.
Indicates the function of the locking knob for the angle guide.
Symbol Meaning
PTS10_WEU.book Seite 4 Donnerstag, 23. März 2006 11:47 11
To Next Page
Loading...
