7.2 Parameterizing/Configuring the Drive
7.2.1 Overview
Fig.7-3: Configuring the Application Example
Starting from basic parameters in the CCD master axis, you have to make some
fundamental settings for the example of application "synchronous multi-axis
motion with virtual master axis". These settings are described below.
DOK-INDRV*-MLD-APPLI**-AW02-EN-P
Rexroth IndraDrive Rexroth IndraMotion MLD Application Examples
Bosch Rexroth AG 53/97
Synchronous Multi-Axis Motion With Virtual Master Axis
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
To Next Page
Loading...
