7.2.3 CCD Slave Axis
Again starting
from the completion of the action "load basic parameters", make
the following settings for the CCD slave axes.
Enabling of Functional Packages
This application example requires the base package "Closed-Loop" and the
enabling of the optional functional package "Synchronization".
It is only allowed to enable licensed functional packages!
Fig.7-11: IndraWorks Dialog to Enable the Required Functional Packages for the
CCD Slave Axis
Settings for Operation Mode "Elec‐
tronic Motion Profile"
Material feed is to take place from the CCD slave axis which is operated in the
"electronic motion profile" mode. In the CCD slave axis, make the settings
shown in the IndraWorks dialog below for this application example and this
operation mode.
DOK-INDRV*-MLD-APPLI**-AW02-EN-P
Rexroth IndraDrive Rexroth IndraMotion MLD Application Examples
Bosch Rexroth AG 61/97
Synchronous Multi-Axis Motion With Virtual Master Axis
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
To Next Page
Loading...
