DOK-INDRV*-HCS02*UL ***-1803-EN-P
Bosch
Rexroth
AG
33/69
Rexroth lndraDrive
Drive
Controllers Power Sections
HCS02
Instructions for Use
Occurring current
load
and
minimum
required
See
technical
data
of device
used
(ILN
and
ALN)
connection cross section
Occurring voltage
load
See
technical
data
of
device
used
(ULN
or
ULN
_ne
nnl
Fig. 5-5:
Function,
Pin Assignment, Properties
5.2.4
X5,
Motor
Connection
Important
Notes
-
!\'4i$M~@-
Lethal
electric
shock
by
live
parts
with
more
than
50
V!
Exclusively operate the device
• with plugged on connectors (even if there haven't been any lines connec-
ted to the connectors) and
• with connected equipment grounding conductor!
- !jtiJIJir•#-
Damage
to
the
device!
Provide strain relief for the terminal connectors
of
the device
in
the control cab-
inet
or
use the optionally available connection accessory HAS02.
Notes
on
Installation
The indicated connection cross sections are the cross sections which can be
connected. Dimension the
required
cross
section
of
the connecting lines ac-
cording to the occurring current
load.
HCS02.1 E-W0012, -W0028
View
r--1 r--1
r--1
~
_c=-=1
A~
A2 A3
@
rr--;
b
1--i
tJ
1-'--\
/---',
DA000173v01_nn.
FH
11
Screw
connection
at
connector
Tightening
torque
•
For optimum shield contact
of
the motor power cable, use our
accessory
HAS02, where possible.
• For the connection between drive controller and motor use our
ready-made motor power cables, where possible (see docu-
mentation "Rexroth Connection
Cables").
•
When using NFD03.1 mains filters, the maximum allowed con-
ductor cross section is limited to 4
mm
2
.
• For selecting the motor cables, observe the information con-
tained
in
the Project Planning Manual "Rexroth lndraDrive
Drive
System"
-->
"Connection Cables to Motor".
ldentifica-
Function
tion
A1
For power connection
U1
at
motor
A2
For power connection
V1
at
motor
A3
For power connection
W1
at
motor
@
For
equipment grounding conductor of motor
Unit
Min.
Max.
Nm
0,5
0,6
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
