Bosch Rexroth lndraDrive HCS02.1E-W0012 03 Series - X9, External Braking Resistor; Important Notes

DOK-INDRV*-HCS02*UL ***-1803-EN-P
Bosch Rexroth AG 37/69
Rexroth lndraDrive Drive Controllers Power Sections HCS02
Connection Diagram
Notes on Installation
Instructions for Use
-------- ---- -~
~ + I --- - -- - -- - -- I
~ ~ ~ '
(~ ~ ~ ~ ~
I
0 0 """
0
~ ~ ~
I A 1 A2 A3 @ ..-- I C\J I (<) I
i xs
'
, - -~
. I
I
I
I
Fig.S-10:
DA 000299v01_ nn . FH 11
The connection of the equipment grounding conductor can either be at
terminal connector X5 or directly at the drive controller (this figure shows
a
terminal connector X5 with connection of the equipment grounding
conductor).
Connection
of Motor Temperature Monitoring and Motor Holding Brake
Make sure the voltage supply for the motor holding at the motor
brake is sufficient. You have to take into account that voltage drops
on the
supply line. Use connecting lines with the highest possible
cross section of the single strands.
An
external contact element is required, if motor holding brakes with
higher currents than the allowed current load are to be supplied at
X6.
5.2.6
X9, External Braking Resistor
Important Notes
- !\i.ftimM~ Lethal electric shock by live parts with more
than 50 V!
Exclusively operate the device
• with plugged on connectors (even if there haven't been any lines connec-
ted to the connectors) and
• with connected equipment grounding conductor!
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com