Bosch Rexroth PS5000 - Display I;O signals

4−18 Electric Drives
and Controls
Bosch Rexroth AG BT 6.190 1070087068 / 01
Operation
4.5.6 Display I/O signals
All the input and output signals of the control can be viewed using the BT
6.190.
L Proceed as follows to display the signals:
1. Press the
key.
2. Use the
or key to move the cursor to the ”DIAGNOSIS” line.
3. Press the
key.
The BT 6.190 opens a screen containing a maximum of 8 signals.
Line 1 provides information on whether the displayed signals are in-
puts or outputs of the control.
The following texts can be shown at the beginning of the 2nd line:
D ”ext.”:
the displayed signals’ type is ”external” (transfer using hardware
input/output). This signal type is indicated by the character ”E” (in-
put) or ”A” (output) before the 2−digit signal number (e.g. E00,
A00, etc.).
D ”int.”:
the displayed signals’ type is ”internal” (the signal is created inter-
nally by the weld timer). This signal type is indicated by the charac-
ter ”I” (internal) before the 2−digit signal number.
The corresponding signal status (active = ”1” / not active = ”0”) is al-
ways shown separated from the signal number by a ”:” character.
4. To display additional signals (max. 8 at a time), press
.
The BT 6.190 opens the next screen.
To jump back to the previous screen, press
.
L To return to the main menu: press the
key.