30/36 Digital axis control VT-HMC...1X | Demounting and replacement
Bosch Rexroth AG, Edition 01.2021, RE 30239-B
11.2 DEMOUNTING THE VALVE AMPLIFIER
NOTICE
Electric arc and short-circuit!
Risk of destruction of system components.
▶ Put plug-in connectors down in a way that no short-circuit fault can occur.
To demount the VT-HMC...1X, proceed as follows:
1. Disconnect connection cables and unplug connectors.
2. Loosen the latch from its snapped-in position using a screwdriver.
3. Carefully remove the VT-HMC...1X from the DIN rail while the latch is pulled
out.
Fig. 14: Removing the VT-HMC...1X from the DIN rail
11.3 PREPARING THE COMPONENTS FOR STORAGE OR
FURTHER USE
Proceed as follows in order to prepare the VT-HMC...1X for storage and further
use:
▶ Use the original packaging for storage.
▶ Observe the permissible storage temperature range specified in RE 30239.
▶ Protect the axis control from dust and humidity.
To Next Page
Loading...
