6/36 Digital axis control VT-HMC...1X | About this documentation
Bosch Rexroth AG, Edition 01.2021, RE 30239-B
SIGNAL WORD
Type and source of danger!
Consequences in case of non-compliance
▶ Hazard avoidance measures
▶ <Enumeration>
• Warning symbol: draws attention to a hazard
• Signal word: identifies the degree of hazard
• Type and source of danger: Specifies the type and source of danger
• Consequences: describes the consequences in case of non-observance
• Precaution: specifies how the hazardous situation can be prevented
Tabelle 2: Hazard classifications according to ANSI Z535.6-2011
Warning sign, signal word Meaning
DANGER
Indicates a hazardous situation which, if not avoided, will
certainly result in death or serious injury.
WARNING
Indicates a hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION
Indicates a hazardous situation which, if not avoided, could
result in minor or moderate injury.
NOTICE
Damage to property: The product or the environment could
be damaged.
1.3.2 Symbols
The following symbols indicate notices which are not safety-relevant but increase
the comprehensibility of the documentation.
Tabelle 3: Meaning of the symbols
Symbol Meaning
If this information is disregarded, the product cannot be used or operated in an
optimum manner.
▶
Individual, independent action
1.
2.
3.
Numbered instruction:
The numbers indicate that the actions must be carried out one after the other.
1.3.3 Designations
The following terms are used in this documentation:
Tabelle 4: Designations
Designation Meaning
VT-HMC...1X Digital axis control
IndraWorks Software
RE xxxxx Rexroth document in English language
Vencoder_ANA Supply voltage for external sensors
To Next Page
Loading...
