Menu item number Functions LED Color
3 Start First Touch, delete network configuration, reset user
name and password
E
D
BT
Red
Red
Red
4 Start First Touch, delete network configuration, reset user
name and password, delete files, restore state upon delivery
E
D
BT
ERR
Red
Red
Red
Red
Tab. 12-4: Menu items of the initial firmware
If the function was executed successfully, the LED "E" changes from
red to green after some seconds.
The control must not be switched off during this time.
The operation mode switch SF1 provides the following options to open the
menu items:
1. Press SF1 < 3 seconds to the position "Clear": Menu item navigation and
selection.
Whenever SF1 is pressed, the next menu item is selected. (1 > 2 > 3 > 4 >
1 ...)
2. Press SF1 > 3 seconds to the position "Clear": Triggering the menu item
function.
The LED "E" changes from red to green.
Triggering the function is displayed by a brief switch-off and switch-on of
the respective LEDs.
3. To confirm the "Factory reset" (menu item no. 4), the operation mode
switch SF1 has to be set to the "Run" position.
The left column is flashing until the additional confirmation of the opera-
tion mode switch is on the "Run" position. The process of restoring the
state upon delivery is displayed by a running down of the right LED col-
umn. The completion of the restoration is displayed with a green LED "E".
The device must not be separated from the voltage supply during that time.
When selecting menu item 4
"Factory reset", all files on the XM2x
control installed since the commissioning are deleted. We recom-
mend to create a system firmware backup (see chapter 12.3.3
"Firmware management" on page 45) before using this function.
The initial firmware is part of the hardware and not deleted.
42/69
Device description
IndraControl XM21, XM22 Controls
Bosch Rexroth AG R911340667_Edition 04
To Next Page
Loading...
