● Gateway
● Subnet mask
Enter a valid network setting and write that setting to the control (press the
Write configuration button). If writing the network settings is completed suc-
cessfully, a note is displayed in the header area of the site. The Reboot control
button is additionally displayed. It is used to restart the control and thus applies
the network setting.
Fig. 12-7: "Network configuration" dialog
The network settings are only applied after a control restart.
12.3.3 Firmware management
The "Firmware management" site of the IndraControl First Touch provides the
following information:
IndraControl XM21, XM22 Controls
45/69
Device description
R911340667_Edition 04 Bosch Rexroth AG
To Next Page
Loading...
