Troubleshootingde
Disturbance Cause and troubleshooting
Leftover food on dishes
dishes.
1.Put the dishes away with enough space.
The spray jets must reach the surface of the dishes.
2.Avoid investment locations.
Spray arm rotation is blocked.
▶ Arrange the dishes so that the dishes do not
hinder the rotation of the spray arm.
Spray arm nozzles are clogged.
▶
Clean the spray arms →
Page 48
.
Sieves are dirty.
▶ Clean the sieves.
→
"Cleaning the sieves", page 47
Sieves are inserted incorrectly and/or not locked.
1.Insert the sieves correctly.
→
"Sieve system", page 47
2.Lock the sieves into place.
Washing program selected that is too weak.
▶ Choose a stronger washing program.
▶ Adjust the sensitivity of the sensors.
Dishes have been pre-cleaned too much. The sensors
determine a weak program flow. Stubborn dirt
sometimes cannot be removed.
▶ Only remove large food residues and do not pre-
wash the dishes.
Tall, narrow vessels are not rinsed sufficiently in the
corner area.
▶ Do not store tall, narrow vessels at an angle or in
corners.
The upper dish rack on the right and left is not set at
the same height.
▶ Adjust the upper dish rack on the left and right to
the same height.
→
"Upper dish rack", page 25
53
To Next Page
Loading...
