deTroubleshooting
Disturbance Cause and troubleshooting
Cleaner residues in
Device
The lid of the detergent compartment is blocked by
crockery and does not open.
1.Place dishes in the upper dish rack so that the tab
drip tray is not blocked by dishes.
→
"Putting away the dishes", page 39
The dishes are blocking the cleaner lid.
2.Do not place dishes or air fresheners in the tab drip
tray.
The cleaner chamber lid is blocked by the tab and
does not open.
▶ Place the tab horizontally in the cleaner chamber and
not upright.
Tabs are used in the quick program or short program.
Tab resolution time is not reached.
▶ Choose a stronger program or use powder cleaner
→
Page 35
.
The cleaning effect and dissolving behavior decrease
with longer storage times or the cleaner clumps
heavily.
▶
Change the cleaner →
Page 35
.
There are water stains
which are on plastic
parts.
Drop formation on plastic surfaces is physically
unavoidable. After drying, water stains are visible.
▶ Choose a stronger program.
▶ Arrange the dishes at an angle.
→
"Putting away the dishes", page 39
▶ Use rinse aid.
→
"Rinse aid", page 34
▶ Set the softening system higher.
Wipeable or
water-soluble coatings
are located inside the
device or
on the door.
Cleaning ingredients build up. These deposits usually
cannot be removed chemically.
▶
Change the cleaner →
Page 35
.
▶ Clean the device mechanically.
White deposits build up inside the device.
1.Set the softening system correctly.
In most cases you will need to increase the setting.
2.Change the cleaner if necessary.
The special salt container is not closed.
54
To Next Page
Loading...
