Troubleshootingde
Disturbance Cause and troubleshooting
▶ Turn the special salt container closed.Wipeable or
water-soluble coatings
are located inside the
device or
on the door.
White, heavily
removable coverings are
on the dishes, inside
of the appliance
room or the door.
Cleaning ingredients build up. These deposits usually
cannot be removed chemically.
▶
Change the cleaner →
Page 35
.
▶ Clean the device mechanically.
Hardness range is set incorrectly or water hardness is
greater than 50 °dH (8.9 mmol/l).
▶
Set up the softening system →
Page 31
Adjust the
water hardness or add special salt.
3in1 cleaner, organic cleaner or eco-cleaner is not
sufficiently effective.
▶
Set up the softening system →
Page 31
on the water
hardness and use separate products (branded
cleaner, special salt, rinse aid).
Cleaner is underdosed.
▶ Increase the dosage of the cleaner or change
the cleaner →
Page 35
.
Washing program selected that is too weak.
▶ Choose a stronger washing program.
▶ Adjust the sensitivity of the sensors.
Tea residue or lip stains
pen residues on the
dishes.
Rinsing temperature is too low.
▶ Choose a program with a higher washing
temperature.
Cleaner is underdosed or unsuitable.
▶ Use a suitable cleaner
→
Page 35
and dose it according to the manufacturer's
instructions.
Dishes have been pre-cleaned too much. The sensors
determine a weak program flow. Stubborn dirt
sometimes cannot be removed.
▶ Only remove large food residues and do not pre-
wash the dishes.
55
To Next Page
Loading...
