Troubleshootingde
Disturbance Cause and troubleshooting
Removable streaks
are located on glasses,
glasses with a metallic
appearance
and cutlery.
The amount of rinse aid added is set too high.
▶ Set the rinse aid system to a lower level.
No rinse aid is filled.
▶
→
"Filling with rinse aid", page 34
Detergent residues are present in the rinse program section.
The lid of the detergent compartment was blocked by pieces
of crockery and did not open completely.
1.Place dishes in the upper dish rack so that the tab
drip tray is not blocked by dishes.
→
"Putting away the dishes", page 39
The dishes are blocking the cleaner lid.
2.Do not place dishes or air fresheners in the tab drip
tray.
Dishes have been pre-cleaned too much. The sensors
determine a weak program flow. Stubborn dirt
sometimes cannot be removed.
▶ Only remove large food residues and do not pre-
wash the dishes.
▶ Adjust the sensitivity of the sensors.
Irreversible glass clouds
exercise.
Glasses are not dishwasher safe, only dishwasher safe.
▶ Use dishwasher-safe glasses.
▶ Avoid a long steam phase (standing time) after the
end of the wash cycle.
▶ Use a lower temperature program.
▶ Set the softening system to the water hardness
level.
▶ Use a cleaner with a glass protection component.
Traces of rust on surfaces
plug.
Cutlery is not sufficiently rust-resistant. Knife blades
are often more severely affected.
▶ Use rust-resistant dishes.
Cutlery also rusts if rusting parts are washed with it.
▶ Do not wash rusty parts.
Salt content in the rinse water is too high.
57
To Next Page
Loading...
