deTroubleshooting
Disturbance Cause and troubleshooting
Traces of rust on surfaces
plug.
1.Remove any spilled special salt from the rinsing
container.
2.Tighten the cap of the special salt container tightly.
There are cleaning residues
in the detergent
chamber or in the
tab collecting tray.
Spray arms were blocked by crockery and the
detergent was not rinsed out.
▶ Make sure the spray arms are not blocked and
can rotate freely.
The detergent chamber was damp when the detergent was
filled.
▶ Only pour cleaner into a dry cleaner chamber.
Unusual ones
foam formation
act.
There is handwashing liquid in the rinse aid
reservoir.
▶ Immediately add rinse aid to the reservoir.
→
"Filling with rinse aid", page 34
Rinse aid was spilled.
▶ Remove the rinse aid with a cloth.
The cleaner or equipment cleaner used forms too
much foam.
▶ Change the cleaner brand.
Disturbance Cause and troubleshooting
Refill indicator for
Special salt lights up.
Special salt is missing.
▶
Fill with special salt →
Page 32
a.
Sensor does not recognize special salt tablets.
▶ Do not use special salt tablets.
Refill indicator for
Special salt lights up
not.
The softening system is switched off.
▶
Set the softening system →
Page 32
Refill indicator for
Rinse aid lights up.
Rinse aid is missing.
1.Fill with rinse aid →
Page 34
a.
2.Adjust the amount of rinse aid added.
Refill indicator for
Rinse aid lights up
not.
Rinse aid system is switched off.
▶
→
""Setting the amount of rinse aid added", page 35
58
To Next Page
Loading...
