Troubleshootingde
Disturbance
Display flashes.
Cause and troubleshooting
Appliance door is not completely closed.
▶ Close the device door.
‒ Arrange dishes so that no parts of the dishes
protrude over the dish rack and prevent the
appliance door from closing safely.
Display for machine
care lights up.
Machine care is recommended.
▶ Run the Machine Care program without dishes.
‒ Use a special machine care product.
The display goes out automatically after 3 wash cycles
without you having carried out any machine
maintenance.
Disturbance Cause and troubleshooting
Water remains
End of program in
device stand.
Sieve system or area below the sieves is clogged.
1.Clean the sieves →
Page 47
.
2.Clean the waste water pump →
Page 61
.
Program is not finished yet.
▶ Wait for the program to end or cancel the
program with Reset.
▶
→
"Cancel program", page 42
Device does not turn
on or is
not to use.
Functions of the device have failed.
1.Unplug the power cord or turn off the fuse.
2.Wait at least 2 minutes.
3.Connect the device to the power supply.
4.Turn on the device.
Device does not start. The fuse in the house is not OK.
▶ Check the fuse in the house.
Power cord is not plugged in.
1.Check whether the socket is working.
2.Check that the power cord is fully plugged into the
outlet and into the back of the device.
Appliance door is not completely closed.
▶ Close the device door.
Program starts
self-employed.
There was no waiting for the end of the program.
▶
→
"Cancel program", page 42
59
To Next Page
Loading...
