Bosch Therm 8000 S - Page 21

6 720 680 174 (2014/05)Therm 8000S
Installation instructions | 21
5.10.1Filling the condensate trap before vent pipe
installation
▶ Fill the condensate trap by pouring approx.14 oz. (400ml)
of water into the exhaust accessory on the top of the
appliance, see Fig. 32.
Fig. 32 Filling the condensate trap at start up
5.10.2Filling the condensate trap after vent pipe
installation
Please proceed as follows;
▶ Remove front cover, see Fig. 24.
▶Open the four clips and remove the combustion cover.
▶ Remove the clip and disconnect the drain tube, see Fig. 33.
Fig. 33
▶ Fill the condensate trap by pouring approx.14 oz. (400ml)
of water into the top of the drain tube. To avoid damage to
the appliance use a funnel in this operation, see Fig. 34.
Fig. 34 Filling the condensate trap after installation.
6720608948-05.1AL
After appliance has been out of use for a long
time or after cleaning the siphon, refill the
condensate trap with water.
6720801993-15.1V