Analog and Frequency Inputs | 11
Bosch Motorsport Vehicle_Control_Unit_VCU_Manual 55/136
A “Characteristic Curve Wizard” opens.
4. To activate the internal pull up-resistor, check the box. The Vehicle Control Unit VCU
pull up-resistor is used to get a 5 V signal at the analogue channel of the Vehicle
Control Unit VCU. It allows you, to use a push-button. The fixed value of the internal
pull up-resistor is 3,010 Ohm. If using an additional external pull up-resistor, set up
the overall resistance.
5. Click ‘Next’ when done.
The second part of the “Sensitivity/Offset Wizard” opens.
To Next Page
Loading...
