de Set up and connect
4.3 Requirements for the
installation site
Installation site
Wooden beam ceiling
conditions
Place the device
on a water
standing wooden
plate (thickness
at least 30 mm)
put up the
firmly to the floor
is screwed.
WARNING
Risk of electric shock!
The device contains live parts.
Touching live parts is dangerous.
▶
Do not operate the device without a
cover plate.
Kitchenette The device only
under through
walking working
set up the plate,
which are firmly
attached to the
ken connected
is. Required
Niche width:
60 cm.
WARNING
Risk of injury!
The device can tip over when
operated on a base.
▶
Before putting the device into operation, it is
essential to secure the feet of the device on a
base with the retaining tabs →
Page 30
of the
manufacturer.
CAUTION!
Freezing residual water in the
device can damage the device.
▶
Do not set up and operate the device
in areas where there is a risk of frost
or outdoors.
If the device is tilted more than 40 °,
residual water from the device can
leak and cause property damage.
▶
Carefully tilt the device.
▶
Transport the device in an upright position.
On a wall No hoses
between wall
and device on
clamp.
4.4 Remove the transport
locks
The device is secured for transport
with transport locks on the rear of
the device.
Installation site
base
conditions
The device with
Retaining tabs
→
Page 30
loading
consolidate.
Notice: Keep the screws of the
transport locks and the sleeves for
later transport →
Page 53
on.
14th
To Next Page
Loading...
