safety de
1.4 Secure installation
When installing the device, follow the safety instructions.
WARNING - Risk of Electric Shock!
Improper installations are dangerous.
▶
Only connect and operate the device in accordance with the
information on the nameplate.
▶
Only connect the device to an alternating current power supply
via a properly installed, earthed socket.
▶
The protective conductor system of the electrical house installation
must be installed according to regulations. The installation must have a
sufficiently large cable cross-section.
▶
When using a residual current circuit breaker, only use one
type with the symbol.
▶
Never supply the device via an external switching device, e.g.
B. timer or remote control.
▶
If the device is installed, the mains plug of the mains connection
line must be freely accessible, or if free access is not possible, an
all-pole disconnecting device must be installed in the fixed
electrical installation in accordance with the installation
regulations.
▶
When setting up the device, make sure that the power cord
is not pinched or damaged.
Damaged insulation of the power cord is dangerous.
▶
Never bring the power cord into contact with hot device parts or
heat sources.
▶
Never bring the power cord into contact with sharp points or
edges.
▶
Never kink, squeeze or modify the power cord.
5
To Next Page
Loading...
