Basic operation de
3. Fold down the dispensing aid and
click into place.
a The drum turns and it
A load detection follows, which can
take up to 2 minutes and then the
water runs in. a The display shows
either pro
duration or the Ready in time is
displayed.
a The display shows after program
end: -0-.
13.9 Soaking laundry
Notice: No additional detergent is
necessary. The washing liquor is
then used for washing.
4th Slide in the detergent drawer.
1. Start the program.
13.7 Adding detergent and care
products
2. To pause the program, open after
approx. 10 minutes Start / reload
to press.
Hints
¡ Use the dosing aid for liquid
Do not use sigwaschmittel with gel-
type detergents, washing powder,
activated prewash or ready-in-time.
¡ Observe the notes on
Detergents and care products
→
Page 31
.
3. To continue the program, click on
after the desired soaking time
Start / reload to press.
13.10 Adding laundry
1. on Start / reload to press.
The device pauses.
1. Pull out the detergent drawer.
Notice: If appears, it is not possible
to add laundry.
2. Pour in the detergent.
→
"Detergent drawer ",
page 20
When goes out, it is possible to add
laundry.
3. If necessary, fill in the care product.
2. Open the appliance door.
3. Add or remove laundry.
4th Slide in the detergent drawer.
4th Close the appliance door.
5. on Start / reload to press.
13.8 Start the program
13.11 Cancel the program
Notice: If you want to change the
time until the end of the program,
ready in-time.
1. on Start / reload to press.
2. Open the appliance door.
set the feet first
▶
on Start / reload n to press.
At high temperatures and high
water levels, the door remains
locked for safety reasons.
33
To Next Page
Loading...
