Home Connect de
15.4 Activate Wi-Fi on the
device
a The network settings are
set back.
a When the display End shows are
reset the network settings.
Notice: The energy consumption
increases compared to the values
specified in the consumption values
table when Wi-Fi is activated.
15.7 Remote start
1. on Remote start approx. 3 seconds
to press.
Enable the device for remote start via
the Home Connect app.
2. Set the program to position 4. a The
display shows Con.
Activate remote start
3. on Start / reload to press,
until the display On indicates.
Hints
¡ The remote start is off
Safety reasons under the
following conditions
deactivated:
- Open the appliance door.
- Start / reload to press.
- Remote start to press.
- Switch off the device.
- After a power failure.
¡ Remote start can be done for safety
cannot be activated when the
appliance door is open.
a Wi-Fi is enabled.
Notice: The device does not turn off
automatically when Wi-Fi is enabled.
15.5 Deactivating Wi-Fi on the
device
1. on Remote start at least 3 seconds
customers push.
2. Set the program to position 4. a The
display shows Con.
requirements
¡ The device is connected to your WLAN
Home network (WiFi) connected. ¡ The
device is connected to the Home Con-
nect app connected.
¡ A program is selected.
3. on Start / reload to press,
until the display OFF indicates.
a Wi-Fi is disabled.
Notice: The connection will be
automatically re-established when the
Wi-Fi is switched on again.
▶
on Remote start to press.
If you press the button for at least
3 seconds, you open the Home
Connect menu. If you press the
button briefly, the appliance is
enabled for remote start via the
Home Connect app.
The function is automatically
deactivated when you open the
appliance door.
15.6 Resetting the network
settings of the device
1. on Remote start at least 3 seconds
customers push.
2. Set the program to position 5.
a The display shows rES.
3. on Start / reload
a The display shows YES.
4th on Start / reload
a Remote start shines.
to press.
Notice: To deactivate the function,
click Remote start to press.
to press.
37
To Next Page
Loading...
