31
INSTALLATION DIAGRAM NOTES
The installation diagrams on the following pages are provided to give you an idea as to how
this product may be installed in the field, so that you can more easily troubleshoot a problem if
the unit has been removed from its installation for you to repair.
The diagrams are divided into three sections:
1. The first section is labelled "Example Listening Zone", and in block diagram format,
shows how the source is connected to the amplifier, and the amplifier is connected to the
loudspeakers as well as the remote volume control(s) for that type of installation.
2. The next section is labelled "Rear Panel Hookup", and shows the hookup on the rear panel
of the amplifier, as well as the various switch settings for that type of installation.
3. The bottom section is labelled "AmPlus™ 50 (or 100) Signal Flow", and in block diagram
format, depicts the signal flow and switch settings for the particular amplifier used for that type
of installation. The grayed out lines in the block diagram indicate signal paths and blocks not
used in that particular application.
Using this information, you should be able to more closely approximate the installation of the
unit in order to more easily troubleshoot it.
To Next Page
Loading...
Need help?
General
