44
Disassembly Procedures
2. Driver Removal
2.1 Perform procedure 1.
2.2 Remove the four screws that secure the
driver to the baffle. Lift out the driver.
2.3 Cut the wires as close to the driver
terminals as possible.
Re-assembly Note: Be sure to observe
polarity when re-connecting the driver wires.
There may be more than one wire per
connection.
3. Logo Removal
3.1 Perform procedure 1.
3.2 Unbend the legs of the logo and lift it off
the grille.
Array Extensions
Note: The array extensions are not repair-
able. If damaged they must be replaced.
To Next Page
Loading...
