Figure
23
OPTIONAL CONNECTIONS AND ADDITIONS
Choosing digital audio
If your
TV,
VCR, tape deck, or AUX component has the proper output jacks, you can
make a digital audio connection
to
the media center (Figure 23).
Media
center
connector panel
Digital audio
and
other
media center panel
connections
Optical
Digital
Audio
IN
jack
Coaxial
Digital
Audio
IN
jacks
• For a coaxial connection, use a 75-ohm cable with RCA connectors. Connect it
to
the
Digital jack for that component:
TV,
CBUSAT, VCR, or AUX.
• For
an
optical connection, insert
an
optical digital cable (with a square connector) into the
Optical
IN
on the media center rear panel.
) Note:
To
make digital recordings from a connected optical component, connect another optical
cable to the Optical
OUT
jacks on the media center rear panel.
Activating
an
optical connection
Before you can listen
to
a source connected
to
the Optical
IN
jack on the media center, you
MUST activate that connection:
1. Turn on your
TV.
2.
On the
L1FESTYLE®
system remote control, press
System.
Use the arrows
to
move around the on-screen menu and press
Enter
to
make selections:
A.
On the
TV
screen, move right
to
Media
Center
and press
Enter.
B. Move down the menu
to
Optical
Source
and press
Enter.
C. Select the component that is connected
to
the media center using optical cable.
D.
Press
Enter
to
confirm this setting.
E.
Press
Exit
to
leave the System menu. This completes activation
of
your optical
connection.
27
To Next Page
Loading...
