You can configure a control tone for each cutting pulse in the
"GastroCut" program. This setting can only be made in the Service
program, and it applies to both "Gastro LOOP" and "Gastro KNIFE".
Changing the cutting speed for "Gastro LOOP"
1. Press the power limitation key for monopolar cutting 4.
2. Press the key for scabbing level 5/6 to swicth between
slow "Gastro LOOP" (non-accelerated),
dynamic " Gastro LOOP" (medium speed; default), and
fast dynamic " Gastro LOOP" (accelerated).
3. Press the power limitation key for monopolar cutting 3 to return to
the menu programs.
Changing the cutting speed for "GastroCut Pap"
1. Press the power limitation key for monopolar cutting 4.
2. Press the key for monopolar coagulation 10/11 to swicth between
slow "Gastro KNIFE" (non-accelerated),
dynamic " Gastro KNIFE" (medium speed; default), and
fast dynamic " Gastro KNIFE" (accelerated).
3. Press the power limitation key for monopolar cutting 3 to return to
the menu programs.
Enabling or disabling the control tone for cutting pulses
1. Press the power limitation key for monopolar cutting 4.
2. Press the key for power limitation bipolar coagulation 23/24 to
enable or disable the control tone for cutting pulses.
3. Press the power limitation key for monopolar cutting 3 to return to
the menu programs.
Pos: 54 /679-BOW A/HF-Geräte/ ARC 200/250/3 00e/6 Bedienung/M enü-Progra mm 4 "Show Pre v Inf-No" @ 5\ mod_127010 9901242_6.doc @ 38626 @ 3
To Next Page
Loading...
