31
6 Operation 6
6.2 Automatic Operation - Brief Instructions
6.2
Open valves for water, steam, condensate, compressed air.
Set up the power supply
Before starting, make sure that all doors and covers are closed.
Main switch "ON"
Display: "BOEWE"
"Textile Cleaning"
Machine type, such as: "P12 "
STOP
START
Then the deodorizing program "P34" is displayed.
Press the "Start " button.
After the signal sounds, press the "Stop" button.
Loading:
Open the loading door, load the cage according to the filling capacity,
close the loading door.
PROG
2
C
Erase the displayed, previous program
P34 by pressing "C".
Select a program according to the overview.
Input the required program
(program and number)
Start:
START
Press "Start".
The program executes automatically.
During automatic and manual operation, the loading door is locked
from the start of the cycle until the end (signal).
If there is a failure or if the door limit switch is not adjusted correctly,
there will be an alarm indication.
A signal that sounds in intervals announces that the program has ended.
STOP
Stop: Press the "Stop" button.
Open the loading door and unload the garments.
Close the loading door.
If you repeat the same program, you only need to load the garments,
close the loading door and press the "Start" button.
If you do not restart the machine, the loading door locks after 1 minute.
You can unlock the door with the "⇑" button for up to 10 minutes.
After 10 minutes, start the deodorizing program "P34".
Caution
Shut the machine down immediately if there are dangers of any kind,
such as if unbalances occur during the spinning cycle. Turn off the
main switch.
P12
To Next Page
Loading...