EasyManua.ls Logo

BÖWE P 12 - Maintenance Program Summary

BÖWE P 12
78 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
57
11 Maintenance 11
11.3 Maintenance Program Summary
11.3
P14 to P33 Free programming locations
P34
Deodorizing: Attention: Always select this program if the loading door
will not open.
The following maintenance programs are installed in the P12/P15
P9
Slimsorba maintenance (only
for machines with Slimsorba)
For desorption of the Slimsorba at times other than during
cleaning cycles. The program has two phases: desorption
and carbon cool-down.
P10/P
35
Filter maintenance 1/2 Start of automatic filter maintenance program with
spinning and simultaneous 50% draining to the still. Then
additional spinning and complete emptying into the still.
Finally, filter circuit and, if filter powder is used, precoating
with the filter powder. Pumping to work tank and spin to
still with subsequent drying and reduction.
If filter powder is used,
fill the bag that comes with the
machine and put it in the cage before the start.
P36 Distillation maintenance Still stripping and subsequent reduction or program
sequence "emission-free still rake out"
P37 Fill tanks Fill the clean tank, then overflow into the work tank
P38 From tank 1 to cage For cleaning the work tank
P39 From tank 2 to cage For cleaning the clean tank
P40 From tank 1 to distillation
P41 From tank 2 to distillation
P42 From cage to distillation
P43 Prepare stock solution Addition of drycleaning detergent in the work tank solvent
by preparation in the pump circuit, with dosing via the
dosing unit (manual operation); then drying with reduction
P44 Transfer pumping of
distillation residues
(Only with emission-free still rake out system)
P45 Program not assigned
P46 Rinse sight-glass, tank 2
For interior cleaning of the sight-glass on tank 2
Pump from tank 2 to tank 2
P47 From tank 3 to cage
For cleaning the extra tank
P48 From tank 3 to distillation
P49 Program not assigned
P50 Neutralization distillation
- Remove button trap strainer
- Fill in product
- Replace button trap strainer
- Pump from work tank and wash neutralization agent into
the still.
- Subsequent drying with reduction.
P12

Table of Contents