BÖWE P 12 - Maintenance; Operation and Maintenance Summary

52
11 Maintenance 11
Attention:
Warranty claims will only be accepted if maintenance has
been performed properly! Follow safety regulations!
11.1 Operation and Maintenance Summary
11.1
When starting operation:
Weekly:
 Turn on steam supply
 Turn on room ventilation system
 Empty and clean water separator
 Turn on cooling water supply  Start Slimsorba maintenance P9
 Turn on compressed air supply  Start drum back plate flushing P51
 Open condensate valve  Wash lint filter mat
 Turn on machine main switch  Drain water from compressed air
armature
 Start deodorizing program P34, press
"STOP" button when program ends and
signal sounds
 Clean the sprayer dirt strainers and
spray nozzles
 Check the function of the disposal vessel
overfill sensor
When stopping operation:
 Start maintenance program P10 when
economy filter at 1.5 bar pressure (at
least every 50 cycles)
Monthly:
 Check pH level (7 –9 indicates good
solvent condition)
 Start distillation maintenance P36 and
wait for signal
 Check solvent levels in the tanks
 Turn off machine main switch  Clean water and steam feeder strainers
 Turn off steam supply  Lubricate cage bearing
 Close condensate valve  Lubricate fan shaft gasket
 Turn off cooling water supply
Semi-annually:
 Turn off compressed air supply
compressor
 Clean air cooler
 Clean tanks
 Turn off room ventilation system or
switch to night operation
 Check V-belt tension, retension
Inspection and maintenance work:
 Retighten screwed unions
Daily:
(before starting the first cycle) Annually:
 Check machine for leaks  Machine inspection (following VBG 66)
 Check solvent safety trough for solvent  Check sacrificial anode, replace if
necessary
 If needed, add neutralization agent to
still
 Remove filter disc and clean in
machine (program P6)
 Clean button trap strainer and lint filter
see 11.5.1)
 Check Slimsorba activated carbon
 Drain water separator water trap into the
process water tank (or safety separator)
 Check water level in still heating
chamber (elec.)
 Check process water tank (or safety
separator), drain if necessary. Dispose
of according to regulations for your
country!
Attention:
 Close loading door and
maintenance openings again
immediately
 Check the liquid level in the cleaning
agent container
 Use only lithium-based lubricating
greases, such as:
 Check small steam generator pressure
gauge level (elec.)
- ALVANIA 3 (SHELL) - MARSON L2 (FINA)
- BEACON 2 (ESSO) - LGMT 3 (SKF)
 Machine is ready for operation
P12