45
9. Control System and Programs 9.
Program sequence (example):
With Slimsorba
P55 Microfibers and special sportswear
with interval spinning
1st bath: Pre-cleaning in pump circuit
,
45 seconds pumping from tank I, pump circuit low level,
2 minutes pump circuit,
1 minute 30 seconds pumping out and spinning to distillation.
2nd bath: Filtration
1 minute pumping from tank I in pump circuit, high level, dosing
1 minute pumping from tank II, pump circuit high level,
4 minutes filtration,
1 minute 15 seconds pumping to tank I,
1 minute 30 seconds spinning to tank I.
3rd bath: Rinsing
45 seconds pumping from tank II, pump circuit low level,
1 minute pump circuit,
30 seconds pumping to tank II,
30 seconds spinning to tank II,
30 seconds spinning run down, pumping to tank II
1 minute tumbling
1 minute spinning to tank II,
45 seconds spinning run down, pumping to tank II
1 minute tumbling
1 minute 30 seconds spinning to tank II
45 seconds spinning run down, pumping to tank II
1 minute tumbling
Spraying
3 minutes 30 seconds tumbling.
Drying
3 minutes predrying, high airflow,
13 minutes drying, high airflow, thermostat I (cage exit) 50 °C (122 °F),
x minutes delay time, drying time controller,
4 minutes afterdrying, high airflow, thermostat I 50 °C (122 °F),
3 minutes reduction
6 minutes adsorption
Wrinkle protection: If you do not press the STOP button at the cycle end, wrinkle protection
deodorizing with gentle reversing continues to run. The machine
automatically stops and locks after a maximum of 7 minutes. You cannot
open it until program P34 has run.
P12
To Next Page
Loading...