Brady i5100 - Notch and Cutout Dimensions for Labels

BradyPrinter i5100 39
Notch/Cutout Dimensions
Callout Description Dimensions
A Label distance (>2 mm)
N Width of cut-out mark (>5 mm)
P Height of cut-out mark (2 - 10 mm)
X Distance mark to middle of paper track
for gap sensor recognition
for reflective sensor recognition
(-10 or 0 mm)
(-56 up to +10 mm)
Y1
Y2
Sensor recognized virtual label front edge
with reflective sensor recognition
(1)
with gap sensor recognition
Front edge cut-out
Rear edge cut-out
Z1
Z2
Distance recognized front edge to actual label front edge
with reflective sensor recognition
with gap sensor recognition using transparent labels
> Adjust software settings
P up to A
0 up to A-P
(1)
Backside of the material must be sufficiently reflective.
Marginal
notch/cut-out
Long hole
notch/cut-out
Rectangular
notch/cut-out
Circular
notch/cut-out
Notch/Cut-out
between labels
Not recommended
Not recommended
Labels with cut-out marks (“notches”)
Continuous material with cut-out marks (“notches”)
Feed direction
for marginal cut-out marks
minimum liner thickness .002 in. (0.06 mm)