Programming PortProgramming Port
A programming port is used to connect the unit to a hand-held
programmer or a PC for quick configuration, also can be connected
to an ATE system for automatic testing & calibration.
Auto-tune
The auto-tune function allows the user to simplify initial setup for a
new system. A clever algorithm is provided to obtain an optimal set
of control parameters for the process, and it can be applied either as
the process is warming up ( cold start ) or as the process has been
in steady state ( warm start ).
Lockout Protection
Lockout Protection
According to actual security requirement, a password is provided to
prevent the unit from being changed abnormally.
Bumpless Transfer
Bumpless Transfer
Bumpless transfer allows the controller to continue to control by
using its previous value as the sensor breaks. Hence, the process
can be well controlled temporarily as if the sensor is normal.
Digital Filter
Digital Filter
A first order low pass filter with a programmable time constant is used
to improve the stability of process value. This is particularly useful in
certain application where the process value is too unstable to be read.
SEL Function
SEL Function
The units have the flexibility for user to select those parameters which
are most significant to him and put these parameters in the home page.
There are at most 8 parameters can be selected to allow the user to
build his own display sequence.
UM0P411A
8
To Next Page
Loading...
Need help?
General
