2-2 Mounting2-2 Mounting
Make panel cutout to dimension shown in Figure 2.1.Make panel cutout to dimension shown in Figure 2.1.
Take both mounting clamps away and insert the controller into
panel cutout. Install the mounting clamps back. Gently tighten
the screws in the clamp till the controller front panels is fitted
snugly in the cutout.
Ta ke both mounting clamps away and insert the controller into
panel
cutout. Install the mounting clamps back. Gently tighten
the
screws in the clamp till the controller front panels is fitted
snugly
in the cutout.
Chapter 2 InstallationChapter 2 Installation
Dangerous voltages capable of causing death are sometimes
present in this instrument. Before installation or beginning any
cleaning or troubleshooting procedures the power to all equipment
must be switched off and isolated. Units suspected of being faulty
must be disconnected and removed to a properly equipped
workshop for testing and repair. Component replacement and
internal adjustments must be made by a qualified maintenance
person only.
Dangerous voltages capable of causing death are sometimes
present
in this instrument. Before installation or beginning any
cleaning
or troubleshooting procedures the power to all equipment
must
be switched off and isolated. Units suspected of being faulty
must
be disconnected and removed to a properly equipped
workshop
for testing and repair. Component replacement and
internal
adjustments must be made by a qualified maintenance
person
only.
Do not use this instrument in areas under hazardous
conditions such as excessive shock, vibration, dirt, moisture,
corrosive gases or oil. The ambient temperature of the areas should
not exceed the maximum rating specified in Chapter 6.
Do not use this instrument in areas under hazardous
conditions
such as excessive shock, vibration, dirt, moisture,
corrosive
gases or oil. The ambient temperature of the areas should
not
exceed the maximum rating specified in Chapter 6.
2-1 Unpacking2-1 Unpacking
Upon receipt of the shipment remove the unit from the carton and
inspect the unit for shipping damage.
If any damage due to transit , report and claim with the carrier.
Write down the model number, serial number, and date code for
future reference when corresponding with our service center. The
serial number (S/N) and date code (D/C) are labeled on the box and
the housing of control.
Upon receipt of the shipment remove the unit from the carton and
inspect
the unit for shipping damage.
If
any damage due to transit , report and claim with the carrier.
Write
down the model number, serial number, and date code for
future
reference when corresponding with our service center. The
serial
number (S/N) and date code (D/C) are labeled on the box and
the
housing of control.
This instrument is protected throughout by -- .
To minimize the possibility of fire or shock hazards, do not expose
this instrument to rain or excessive moisture.
Double InsulationThis instrument is protected throughout by -- .
To
minimize the possibility of fire or shock hazards, do not expose
this
instrument to rain or excessive moisture.
Double
Insulation
Remove stains from this instrument using a soft, dry cloth.
Don't use harsh chemicals, volatile solvent such as thinner or strong
detergents to clean the instrument in order to avoid deformation or
discoloration.
Remove stains from this instrument using a soft, dry cloth.
Don't
use harsh chemicals, volatile solvent such as thinner or strong
detergents
to clean the instrument in order to avoid deformation or
discoloration.
UM0P411A
32
To Next Page
Loading...
