TRANSMISSION / HYD FUILD FILTER
REPLACEMENT
1. After draining the engine oil, turn
the cartridge to the left with the l-
ter wrench.
2. Apply a thin lm of oil over the rub-
ber ring on the bottom of the new
cartridge and attach the new lter
securely.
3. After changing the engine oil, start
the engine and run it until the en-
gine oil pressure warning lamp is
turned off .
4. After the oil pressure warning
lamp is turned off, check the oil
level again. Add oil as necessary.
LXN5O708A
(1) Hydraulic Oil Filter
The lter is a cartridge type.
Fir st 5 0hr, fil ter has to be
changed.
•
NOTE
REPLACEMENT
1. After draining the transmission u-
id, turn the cartridge to the left to
take it out.
2. Apply a thin film of fluid over the
rubber ring on the bottom of the
new cartridge and attach the new
lter securely.
3. After changing the transmission
fluid, start the engine to circulate
the uid and then stop the engine.
Check the uid level at dipstick on
left axle housing and add uid as
necessary.
To Next Page
Loading...
