2. Rinse the radiator with tap water
until no dirt or rust comes out.
※For better results, fill the radia-
tor with water mixed with radiator
flush, run the engine for over 15
minutes, and drain the water solu-
tion
3. Replace the drain plug, add anti-
freeze and ll the radiator with tap
water.
4. Replace the radiator cap and run
the engine to mix the anti-freeze
and water.
D o n o t o p e n t h e r a d i a t o r
cap while the engine is run-
ning or right after the engine
is stopped. Open the radia-
tor cap only after the engine
is stopped and fully cooled
down.
[Otherwise]
Hot water will splash and may
cause burn injury.
•
DANGER
Anti-freeze has an effect of lowering
the freezing point of water. This trac-
tor is filled with international genu-
ine anti-freeze when delivered from
the factory. As the freezing point may
differ depending on the mixture ra-
tio, refer to the following table in very
cold weather to ensure safety.
Outdoor
Temp (‘F)
23 14 5 -4 -13 -22
Ratio (%) 82 73 66 61 55 49
Anti-
Freeze
(%)
18 27 34 39 45 51
When replacing the coolant,
add anti-corrosive solution
and run the engine for about
water.
to the manufacturer’s instruc-
tions.
only tap water.
year, replace the coolant every
year.
•
•
•
•
CAUTION
To Next Page
Loading...
