What to do if I see spider particles on the drive support plate of my Bredel Water Pump?
If you observe spider particles on the drive support plate, it indicates a damaged spider in the flexible coupling. You should check the alignment and replace the spider. Also, inspect the condition of the coupling halves, replacing them if necessary.
Why is there a rattling or squeaking noise near the pumphead of my Bredel Water Pump?
A rattling or squeaking noise near the pumphead suggests a damaged bare shaft kit bearing. Check the alignment. Inspect the bearing and the seal, and replace them if needed.
Why is there cyclic movement of the pumphead in my Bredel Water Pump?
Cyclic movement of the pumphead is caused by misalignment of the pumphead and drive. Check the alignment of pumphead and drive. Also, verify the fixation of the pumphead and the drive to the support set, as well as the fixation of the support set components.
General| Hose Inner Diameter | 25 mm |
|---|---|
| Maximum fluid temperature | 80°C |
| Hose material options | Natural rubber, EPDM, Hypalon |
| Connections | DIN |
| Application | Chemical, food, and beverage industries |
To Next Page
