5. Check that the hose clamps (C) are not damaged and replace them if necessary.
6. Slide the flange bracket (B) and the hose clamp (C) over the hose together. Align the holes in
the flange bracket with the ones at the front of the port. Position the retaining bolts (A) and
tighten them until they are approx. 5 mm from the port, so that the gap between the flange
bracket and the port remains.
7. Slide insert (B) in flange (A) and press the insert in the hose. If necessary lubricate the insert
with Bredel Genuine Hose Lubricant in order to simplify mounting. Make sure that the holes in
flange (A) are aligned with the holes in flange bracket (C). Check that the insert is in the correct
place. If the insert is not positioned correctly, the product to be pumped or the lubricant may
leak.
8. Turn the rotor in such a way that the hose (A) is pressed firmly against the flange surface (B).
52 m-bredel-25-32-en-05
To Next Page
Loading...
