8 Maintenance
8.1 General
WARNING
Disconnect and lock the power supply to the pump drive before any work
is carried out. In case the motor is fitted with a frequency controller and
has a single-phase power supply, wait two minutes to make sure that the
capacitors have discharged.
WARNING
Do not remove the pump cover if the power cable is connected to the
motor. Do not connect the power cable to the motor if the pump cover is
removed.
CAUTION
Only use original Bredel parts when maintaining the hose pump. Bredel
cannot guarantee correct operation and any consequential damage that
occurs from the use of non-original Bredel components.
CAUTION
Check that all components are present. Inspect components for damage in
transit. If anything is missing or damaged, contact your distributor
immediately.
Note: Do not install damaged parts. If in doubt, contact your Bredel
representative for advice.
8.2 Maintenance and periodic inspections
The following maintenance schedule shows the maintenance and periodic inspection that need to be
carried out on the hose pump to guarantee optimal safety, operation and life of the pump.
Note: It is also necessary to carry out periodic inspection of the gearbox and the electric motor.
Consult their separate manuals to guarantee an optimal safety, operation and life of the gearbox and
the electric motor.
m-bredel-25-32-en-05 41
To Next Page
Loading...
