Bredel 25 - Page 42

Item Action To be carried out Remark
1. 
Check the lubricant
level.
Before start-up of the
pump and at scheduled
intervals during
operation.
2. Check that the lubricant
level is above the minimum
level line in the inspection
window. If necessary refill
with Bredel Genuine Hose
Lubricant via the breather
plug.
Refer to "Changing lubricant" on
page 45
3. 
Regularly check the
pumphead for any
leakage around the
cover, the hose
connections, and the
rear of the pumphead.
Before start-up of the
pump and at scheduled
intervals during
operation.
Refer to "Troubleshooting" on
page 76
4. 
Check the gearbox for
any leakage.
Before start-up of the
pump and at scheduled
intervals during
operation.
In case of doubt, consult your
Bredel representative.
5. 
Check the pump for
deviating temperature
or strange noises.
At scheduled intervals
during operation.
Refer to "Troubleshooting" on
page 76
6. 
Check the pressing
shoes for excessive wear
or damage.
When replacing the
hose.
Refer to "Changing the hose" on
page 46
7. 
Internal cleaning of the
hose.
Cleaning of the system
or fluid change.
Refer to "Cleaning the hose" on
page 44
8.  Replace the hose.
Preventive, this means
after 75% of the hose
life of the first hose.
Refer to "Changing the hose" on
page 46
9.  Change the lubricant.
After every second
hose change, after
5000 service hours,
after a year or after
hose rupture
whichever comes first.
Refer to "Changing lubricant" on
page 45
42 m-bredel-25-32-en-05