Bredel 25 - Page 83

• After surface preparation, one layer of two-component acrylate is used for surface protection.
Standard colour is RAL 3011, other colours are optional. Contact your Bredel representative for
advice on surface treatment.
• All galvanised parts have an electrolytic zinc layer of 15 - 20 µm.
Lubricant table pump
Item Bredel 25 Bredel 32
Lubricant Bredel Genuine Hose Lubricant Bredel Genuine Hose Lubricant
Required quantity [litres] 2 3.5
Bredel Genuine Hose Lubricant is registered at NSF: NSF Registration No 123204; Category Code H1.
Also refer to: www.nsf.org/certified-products-systems, and search for 'Bredel'.
Components
Glycerol
(C
3
H
8
O
3
)
50-100% w/w
Glycol
(C
3
H
8
O
2
)
2.5-10% w/w
Water
(H
2
O)

Note: Contact your Bredel representative for advice if you require additional information with respect
to the safety data sheet.
WARNING
It is the users responsibility to ensure the chemical compatibility of the
fluid to be pumped with the lubricant in the pumphead. Obey the local
Health and Safety regulations.
An alternative lubricant is available based on silicone. Also compatibility with this lubricant must be
checked if applied. Refer to the chemical compatibility chart at www.wmftg.com/chemical or contact
your Bredel representative for advice.
Weights
Description
Weight [kg]
Bredel 25 Bredel 32
Pumphead 39 58.5
Flange connection (2x), without inserts 3.72 5.52
m-bredel-25-32-en-05 83