12
If the display indicates an error mode (see section “3.6 Display”) check section “3.8 Error
States” for possible resolutions.
If any or all of the Zone Lights remain constantly lit, check for any obstruction in the detection
area, which may be detected by the sensor, and remove it. If this is not possible as the object
is part of the vehicle, move the sensor so it is not detecting such object(s). If it is not possible
to relocate the sensor, then it may be necessary to install the BS-8000 or consult Brigade for
advice, see section “3.4.3 Vehicle Overhang into Detection Area”.
If the system is working as described, follow the section “5 Testing and Maintenance”. Add the
results from the test procedure in section 5, the configuration data (BS-8000 only) and this
installation and operation guide to the vehicle documentation accessible for the relevant
people.
3.8 Error States
If the display shows an error state (see section “3.6 Display”) check for the following potential
issue below. If the error is resolved the display will return automatically after a few seconds
and the self test to normal operation.
Sensor or extension cable not connected.
Action: Check all connectors are plugged together fully.
No data connection between sensor and display.
Action: Check for damage on connectors and cable.
No power connection to sensor.
Action: Check for damage on connectors and cable.
CAN communication error with sensor.
Cable is routed or system is installed too close to an electric noise source in vehicle.
Action: Try to relocate affected part of the system.
Data corruption in sensor.
Action: Consult Brigade for advice.
The Brigade Backsense
®
Systems cannot self-diagnose potential sensor detection issues
caused by the build up of ice, dirt, mud, heavy rain or immersion in water, which may impede
system performance. Therefore, follow the section “5 Testing and Maintenance”.
To Next Page
Loading...
