Brivis ZonePlus B061006 User Manual

19
7.2 System Operation
Instruct home owner on system operation including:
• System design – MTSP or STSP
• Zone identification
• Minimum / maximum no. of simultaneous zones for design
conditions for Heating and Cooling (if fitted)
• Common Zone operation (if applicable)
• Constant Zone operation (if applicable)
• Operating the system (NC-6) manually
• Auto Operation – programming (NC-6) Comfort Schedule
Refer to ZonePlus Owner’s Manual for detailed instructions.
7.3 Product and Warranty Registration
Brivis recommends the registration of all products to ensure
efficient product support if and when required.
Please inform the home owner that product registration can be
completed:
• on-line at brivis.com.au
• or via the registration form in the product Owner’s Manual
(i.e. Heater Owner’s Manual)
7.4 Service Notification Message
When the operating hours logged for an appliance exceeds the
predetermined period, the NC-6 displays the following
messages:
For Australia: (default: “ID73:1”)
“Fan run hours indicate it is time for a service call – For
assistance call 1300 BRIVIS”
For New Zealand: (
Change “ID73” from “1” to “2”)
“Fan run hours indicate it is time for a service call – For
assistance call 0800 427 484”
Refer to “n01 ID73:#”, Table 8 for details.
The ‘Spanner’ icon will flash once every second on the
NC-6 display. The owner can book a service call or clear the
spanner icon notification by pressing Key “4” on the Master
Controller.
7.5 ZonePlus Commissioning Information
Please ensure all system configuration and installer
parameters have been set and recorded in the ZonePlus
Installer’s Manual and the ZonePlus Owner’s Manual.
These should be left with the home owner for future reference
by the dealer or other service personnel.
8.0 Trouble Shooting Guide
General
• The Brivis NC-6 Networker comes with in-built diagnostics
to assist in determining the cause of a fault
• With some faults the system will attempt to automatically
restart, often several times
• Critical faults, where the equipment cannot automatically
restart, will require a service call
• Refer to the Troubleshooting section of the Brivis product
Installer Manual for specific equipment related issues
before calling for service
• Refer to ZonePlus Owner’s Manual Troubleshooting section

Brivis ZonePlus B061006 Specifications

General

Brand	Brivis
Model	ZonePlus B061006
Category	Controller
Language	English