© 2022 Brivo Systems LLC. All rights reserved. PUB-Brivo ACS6100 Installation Manual
11
Brivo ACS6100 Installation Manual
Follow safety precautions
WARNING: Fire Code
Never connect a keypad/reader or lock to doors without rst consulting the applicable re code. You must consult
with, and get approval from, local re ocials before installing locks or devices on any doors that may be re exits.
Use of egress push buttons may not be legal. Single action exits may be required. Always obtain proper permits and
approvals in writing before installing equipment
WARNING: Fail Secure Mode
Do not install the system in the fail secure mode unless permitted by the local authority having jurisdiction. Doing
so may cause interference with the operation of panic hardware.
WARNING: Heat and Noise
Do not install the control panel in an area that could drop below 32 degrees FAHRENHEIT (0 degrees CELSIUS) or ex-
ceed 125 degrees FAHRENHEIT (52 degrees CELSIUS). Doing so can cause damage to components within the control
panel.
Do not install the control panel near or on the same circuit with devices that produce large amounts of electrical
noise. This includes grinders, electric motors and blowers, electrical switch-gear and other electrically noisy equip-
ment. Electrical noise can interfere with panel operation. If it is not possible to install the panel away from such
sources of noise, it is advisable to isolate it by using a high-quality UPS (Uninterruptible Power Supply) between the
AC Mains and the transformer.
WARNING: Humidity
Do not install the control panel in an area that could experience humidity greater than 85 percent non-condensing.
To Next Page
Loading...
