Brivo B-ACS6100L-E - Verify Shipping Contents

© 2022 Brivo Systems LLC. All rights reserved. PUB-Brivo ACS6100 Installation Manual
7
Brivo ACS6100 Installation Manual
requirements regarding TCP/IP conguration parameters and information about security
considerations.
2. For Brivo Access accounts, make sure the account has been created and the control panel is registered
through Brivo. If the control panel has not been registered by the dealer, the installer may either contact
Brivo Technical Support for assistance or simply register the panel directly.
3. Verify that the Primary Administrator and any other employee(s) who will be accessing the system have
Internet access on a computer equipped with a supported Web browser.
Verify shipping contents
1. Locate and check the contents of the Control Panel kit.
The B-ACS6100R-E/S control panel kit should contain the following parts:
a) 1 metal chassis. Packed inside the chassis are:
• An identify label to be adhered to the inside of the door.
• 1 cardboard box containing the MAIN CONTROL BOARD and MAIN CONTROL BOARD
accessories.
• 1 MAIN CONTROL BOARD
• 1 anti-static bubble wrap bag
• 1 MAIN CONTROL BOARD Accessory Kit
• 1 zipper bag
• 2 metal oxide varistors
• 16 2k ¼W 5% resistors
• 5 B-ACS6000-MBE style standos
• 5 B-ACS5000-MBE style standos
• 1 dipole antenna – 2dB (Wi-Fi antenna)
• 1 IPEX cable (Wi-Fi cable)
• 1 earth ground screw
• 1 4P power wire harness
• 1 identity label
• 1 cardboard box containing a power supply board (B-ACS6100-PSB) and PSB
accessories.
• 1 power supply board
• 1 anti-static bubble wrap bag
• 1 power supply board accessories kit
• 1 zipper bag
• 4 screws
• 1 identity label
b) 1 cardboard box containing accessories, including:
• 1 Pre-assembled CAN Bus cable
• 1 AC/DC power adapter
• 1 14Ah lead-acid battery or 2 7Ah lead-acid batteries
c) 1 lock and key set
d) 1 documentation set, including:
• Installation Manual (this document)
2. The B-ACS6100L-E/S control panel kit should contain the following parts:
a) 1 metal chassis. Packed inside the chassis are:
• An identify label to be adhered to the inside of the door.
• 1 cardboard box containing the MAIN CONTROL BOARD and MAIN CONTROL BOARD
accessories.
• 1 MAIN CONTROL BOARD
• 1 anti-static bubble wrap bag
• 1 MAIN CONTROL BOARD Accessory Kit